11 Major Factors Affecting the Construction of Stadium Plastic Running Tracks
Publish:
2025-02-19 15:03
Source:
The spatial interval between adjacent courts varies greatly. If two or more adjacent parallel acrylic tennis courts are built, the distance between the sidelines of adjacent courts shall not be less than 4 meters.
1. Spacing between the connected areas of multiple courts.
2. For two or more adjacent parallel acrylic tennis courts, the distance between the sidelines of adjacent courts should not be less than 4 meters.
3. Soil thickness of the site, groundwater position, and court orientation.
4. To prevent blistering and peeling of the plastic track surface after paving, the density of the base layer must be strictly controlled to prevent poor embedding of the cement base layer itself, peeling, delamination, resulting in poor bonding strength, surface gasification, and tearing of the surface. Areas where the base layer density is insufficient can be reinforced by drilling, injecting glue (rubber nails).
5. Areas of the base contaminated and corroded by diesel fuel should be removed and filled with glue.
6. Selection of cement or asphalt base.
7. The surrounding fence height of an outdoor tennis court is generally 4 meters, and can be adjusted according to the surrounding environment and building height.
8. For indoor acrylic tennis courts, the minimum height above the end line 6.40 meters away is 6.40 meters. The minimum indoor ceiling height above the net is 11.50 meters.
9. For tennis courts requiring lighting installation, in addition to indoor ceiling light distribution, outdoor acrylic tennis courts should not have lighting fixtures above the court and on either side of the end lines. Outdoor court lighting fixtures should be installed on both sides of the court, at least 6.0 meters above ground, evenly illuminating the court from both sides. A standard tennis court usually requires 8 sets of 1000W tennis court-specific lighting fixtures.
10. The actual thickness of the glue layer is measured from the bottom of the glue to the center of the top layer of glue particles. This is generally controlled in two ways. First, the thickness is pre-checked by using a formwork, and areas with excess height are trimmed or hammered down. If the excess is not significant, a flat scraper with a clamping device can be used to ensure an even thickness of 5mm.
11. To ensure flatness and slope, after nailing the strips, use a level to simulate and check. For high areas of the base layer, level first. For low areas, fill with glue.
Next:
Related News
On November 22, 2021, after review by the Credentials Examination Committee of the Standing Committee of the Fourth People's Congress of Suizhou City and the 32nd meeting of the Standing Committee of the Fourth People's Congress of Suizhou City, Comrade Jin Chao (Chairman of Hubei Qiao Shifu Sports Industry Co., Ltd.) and 335 others were successfully elected as deputies to the Fifth People's Congress of Suizhou City.
2025/02/12
Master Qiao Sports Flooring Brand Promotion Meetings Successfully Held in Zhengzhou and Nanjing!
Staying true to our original aspirations, forging ahead unwaveringly—Master Qiao is always on the road. From October 15th to 17th, 2021, Jinbang Group held two promotional meetings for the Qiao Shifu sports flooring Brand, themed "Gathering Momentum, Moving Forward, Winning the Future," in Zhengzhou, Henan and Nanjing, Jiangsu respectively.
2025/02/12
Jinbang Group's Q1 2021 Summary Conference Successfully Concluded
To enhance internal cohesion, foster camaraderie among colleagues, improve employees' business knowledge, and cultivate a positive team spirit, Jinbang Group held its first annual fun sports meet and company-wide launch conference from April 6th to April 9th, 2021.
2020/04/08
Design and Equipment Specifications for Plastic Badminton Courts
The badminton court is rectangular, with all lines 4 centimeters wide. There should be no obstacles within 12 meters above the court and within 4 meters of the sides. The net is 1.524 meters high in the center and 1.55 meters high at the doubles sidelines.
2025/02/19
Plastic tennis court design and equipment specifications
The playing field should be a rectangle 78 feet (23.77 meters) long and 27 feet (8.23 meters) wide. It is divided in the middle by a net suspended from a rope or cable with a maximum diameter of 1/3 inch (0.8 centimeters).
2025/02/19
Service Hotline
Room 1505, Building A2, No. 23 Middle Spectrum Road, Huangpu District, Guangzhou City, Guangdong Province
©2025 Guangdong Jinbang Sports Facilities Co., Ltd.
Business License
Privacy Policy | SEO | CitySite | Support: 300.cn Dongguan